To advertise on AUGI, please contact the Augiworld Magazine staff. We also recognize blatant self promotion. We realize that there is a gray area where it may be necessary to do so to provide technical solutions. So the instructions in my old copy enabled me to create a modified version of the Earth hatch pattern, import it into Revit and then use it as the cut pattern for the material applied to topography in a Revit project. The concrete hatch pattern is applied to the foundation surfaces (see Figure. But fortunately hatch patterns in AutoCAD have not changed very much in nearly 20 years. You can also fix the problem with a more precisely specified hatch pattern as an alternative to adjusting drawing limits or moving SNAPBASE to and fro.įurther information on this subject can be found here - Advertisement material *removed*, for further information please refer to the following -ĭo not post advertising or self promotional material or links to them to the Forum. AutoCAD finds the boundary of that area and displays its ghosted form. Most hatch patterns lose registration on very extended repetition, some faster than others. The pattern works fine up close to the hatching origin, which is why moving SNAPBASE or the UCS closer to the hatched area helps - fewer repetitions of the hatch pattern occur between the origin and the viewed pattern portion. The problem is a result of inadequate numerical precision in the pattern specification showing up at locations remote from the hatching origin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |